Blog

5 Common Problems Electrical Contractors Face | Arlington, TX

5 Common Problems Electrical Contractors Face | Arlington, TX

In today’s modern world, people have come to rely on electricity. When the electricity goes off, people often do not know what to do with themselves. There are many appliances that do not work without electricity and these appliances bring people comfort and entertainment. If your electricity goes out then it can be caused by a variety of reasons thus it is best to hire electrical contractors to assist you in these matters. Tioga Plumbing & Electric in Arlington, TX would like to inform you of five different problems that electrical contractors face so that you know when it is time to hire an electrical contractor.

1. Power Dips

Your electrical system is connected to various other systems in your house. Your electrical system should be able to handle quite a few appliances without trouble. If the appliance is faulty or damaged then it can cause dips in the power. Power dips are categorized by lights that go dim and bright again. This can happen once the appliance is turned on or this can continue to happen as the device stays on. The dimming of the lights is caused by the appliance drawing too much electricity. Electrical contractors will look at your power grid to make sure that nothing is amiss before finding the faulty appliance. Faulty appliances often have to be replaced but in some cases, they can be repaired. Your electrical service provider will be able to suggest places where your faulty appliances can be repaired.

2. Frequent Electrical Surges

An electrical surge occurs when there is a massive increase in the voltage of the electricity that is fed into your house. This spike in voltage can damage your appliances because they are not designed to be able to handle voltage above a certain point. Sometimes power surges can be caused by a storm, damaged power lines, or a house that has poor electrical wiring. Power surges can damage electronic devices beyond repair and replacing them regularly is very costly. If you are experiencing electrical surges then it is best to contact local electrical contractors to take a look at your home to determine the cause of these surges. They might install surge protectors on your outlets that will protect your appliances or they will have to fix the wiring within your home.

3. Breakers That Trip Often

Circuit breakers are installed onto your distribution board to help protect your home against irregular currents or appliances that use too much electricity. Your circuit breaker will shut off the main supply of energy to your house when an irregularity is spotted. This is to help prevent electrical fires from starting and to protect the rest of the electrical system from damage. If you notice that your circuit breaker is tripping more often than usual then Tioga Plumbing & Electric in Arlington, TX would recommend that you hire electrical contractors. Your circuit breaker might be faulty and you would require a new one or some of your wiring might be faulty and will need to be replaced. It is always best to hire a contractor when it comes to anything electrical-related. Electricity is powerful and one mistake can kill you or leave you disfigured.

4. Uncovered Junction Boxes

The junction box in your house has a bunch of wires that are connected to each other as well as various areas of your house. In order to prevent electrical shocks, your junction box should have a cover. The cover will prevent children from getting close to the dangerous wires. You will have to contact electrical contractors to have a replace the cover for you. While they do that, they can also inspect the junction box to make sure that all the connections are functional and in good condition. Even though an uncovered junction box does not seem like a big problem. A covered junction box can prevent electrical fires and shocks to your loved ones.

5. Overloaded Circuit Panel

Your circuit panel or distribution board in your home is only able to accommodate a certain amount of appliances and electronic devices. If you are using too many appliances then your electrical system cannot handle the demand which causes the circuit breaker to trip often to avoid damages to your electrical system. A quick solution would be to unplug all the appliances that are not being used. If the problem persists then it is best to hire an electrical contractor because there might be a much larger problem that you are unaware of. Another problem is that some people think that installing more circuit breakers than required will increase the safety of their system. Using a tandem breaker in one slot instead of two single pole breakers is a code violation. That is why it is important to hire electrical contractors that are trained and have the needed experience to carry out electrical repairs according to the safety standards. This is also why you should not attempt electrical repairs yourself. It can lead to many code violations that will put the safety of your family and home at risk.

Now that you know which problems electrical contractors face, you will be able to identify them in your home and determine that it is best to call a professional. Leaving it up to a professional will save you a lot of time and effort. If you hire Tioga Plumbing & Electric then you be hiring the best electrical contractors that provide a wide variety of services for any and all of your electrical needs. You will not have to look around to find a great service provider which is convenient.

Contact Tioga Plumbing & Electric in Arlington, TX today to schedule an appointment.

Photo By The Toidi at Shutterstock